Drying

For automatic controllers which control dehumidifying dryers, first indicator show state and operation of heat pumps. Next to indicator, a text description of current heat pump state is shown.

Following text might appear:

wait - controller is waiting because spraying is active
cond - controller is waiting for certain condition to be met
ack - waiting to get confirmation from the heat pump
work xxx min - heat pump will work for xxx minutes
off xxx min - heat pump will be turned off for xxx minutes

Below this indicator there is an indicator for fan cooling / drying. If this output is set to work with drying function, the indicator is constantly lit. If the output has cooling function, this indicator is flashing.

For automatic controllers for conventional dryers with ON / OFF type of control, there is only one indicator here for drying and it is lit whenever the output is turned on.

ON/OFF drying is off	ON/OFF drying is on

For automatic controllers for conventional dryers with PI type of control, this block shows how much drying dampers are open in percent.

For automates MC-600 and MC-2000 drying control can be manage manually. This is possible since version 1.0.6.4.

When the mouse hover above Drying panel, the mouse pointer changes to . Right click on the Drying panel opens pop-up menu, which content depends on the type of drying (ON/OFF or PI).

ON/OFF drying	PI drying

auto - output is managed by MC according regime	auto - output is managed by MC according regime
off - output is in manual mode and turned off	off - output is in manual mode and turned off
on - output is in manual mode and turned on	open - output is in manual flaps-opened mode
	close - output is in manual flaps-closed mode

While output is in manual mode, the display panel changes to

Back