When the program is started separate window will be opened for each automatic controller. Actual look of the windows will be different depending on the type of automatic controller.Upon application start-up, all windows for automatic controllers will perform initialization procedure, i.e.. read all available data from the automatic controllers and configure process and additional data according to data received. During this time window title will show label - inic and access to window is not possible.
After initialization is finished, window becomes available and -inic label in the window title will display OK. After that full control of automatic controller is possible.
If the appropriate automatic controller is not connected or no communication with him is established, label time_out will be shown in title bar. In this case it is impossible to perform any action on automatic controller.
During normal operation, each automatic controller window show states and activity of each output (heating, drying, moistening), operation and direction of the fan, the state of heat pumps, current phase of drying process, statistical parameters and operating time, measured and set values for air temperature, air humidity, average wood moisture content, as well as measured values of individual probes.
Saving - only for automatics that have this possibility
Thermal treatment - only for automatics that have this possibility
